OPERATION GUIDE
1. CHARGE
Fully charge the device before first use. Please use the included USB-C cable to charge your device. The red power light is on while charging, and the green power light is always on when fully charged.
2. FILL THE GLASS BUBBLER
Fill the glass bubbler with water no more than the red line.
Do not fill glass while attached to the battery.
Note: Water will damage the battery. Do not overfill glass or blow into the mouthpiece when the bubbler is settled.
3. INSTALL
Install the glass bubbler and heating element properly.
4. USE
Use the quartz coil to dip a small amount of concentrate.
5. POWER ON/OFF
Click the power button 3 times consecutively to turn it on. The power light will flash 3 times. Then the corresponding temperature light illuminates when the unit is on.
Green: 60%-100%
White: 20%-60%
Red: UNDER 20%
6 . TEMPERATURE SETTINGS
The BURJ has 3 temperature settings. Click the power button twice to change temperature settings.
White: Low - 545°F/285°C
Green: Medium - 608°F/320°C
Red: High - 680°F/360°C
7. HEATING AND INHALE
On-Demand Mode: After you turn on the BURJ, press and hold the power button for vaping for a maximum of 20 seconds.
Draw Active Mode: After you turn on the BURJ, it’s unnecessary to hold the button to heat up while inhaling with a maximum 10-second session. No need to change the mode.
Note: Inhaling gently will produce the best results.
8. CLEAN
1st: Remove the heating element and the bubbler.
2nd: Soak in alcohol for no more than 3 minutes to clean the heating element after each use. Once clean, allow to air dry or dry off with a soft cloth or towel.
3rd: Use a brush or cotton swab to clean the air path of BURJ.
4th: Use some warm water or alcohol to clean the bubbler.
9. ATOMIZER REPLACEMENT
Simply remove the atomizer cap, then unscrew the used heating element from the base. Once the used heating element has been removed, you may now install the new one by screwing it directly into the device. Then re-install the atomizer cap for a new vaping directly.
Note: You may need to press the heating element a little bit when installing the new coil.
BURJ fits 510 thread Cartridge
MAINTENANCE
After using the BURJ or charging, please allow the device to cool down before storage. It should be stored in a cool, dry place protected against the effects of weather and out of the reach of children and pets. If you have any concerns or if there is any problem, please switch off the BURJ and/or remove it from the charger immediately. Do not try to remedy any defect yourself. Contact our customer service directly at support@kingpalm.com.
Note:
Do not touch the heating element immediately after use.
Do not submerge or clean the battery with water or isopropyl alcohol.
Always detach the BURJ heating element from the battery prior to cleaning.
Comments
0 comments
Article is closed for comments.