Giza - Concentrate Vaporizer Manual/Instructions

OPERATION GUIDE

1. CHARGE

Fully charge device before first use. Please use the included USB-C cable to charge your device. Device power light flashes when charging, and turn off automatically when fully charged.

2. FILL THE GLASS BUBBLER

Fill glass bubbler with water no more than the red line.

Do not fill glass while attached to battery.

Note: Water will damage batter. Do not overfill glass.

3. INSTALL

Install the glass bubbler, heating atomizer and silicone mouthpiece tip properly.

4. LOAD

Use the dab tool to place a small amount of concentrate or essential oil. Then put the carb cap back.

Note: Do note overfill. Overfilling can damage your device.

DO NOT OVERLOAD THE DEVICE CHAMBER WITH DESIRED MATERIALS, FOR DEVICES WITH VARIABLE TEMPERATURE SETTING, PLEASE FIND THE BEST SETTING THAT IS COMFORTABLE AND SAFE FOR YOUR ENJOYMENT.

5. POWER ON/OFF

Click the power button 3 times consecutively to turn on. The power light will flash 3 times. Then the corresponding temperature light illuminates when the unit is on.

White: 60%-100%

Green: 20%-60%

Red UNDER 20%

6. TEMPERATURE SETTINGS

The GIZA has 3 temperature settings. Click the power button twice to change temperature settings.

White: Low - 536°F/280°C

Green: Medium: 608°F/320°C

Red: High: 662°F/350°C

7. HEATING AND INHALE

Click the power button once to start heating. The device will pre-heat in 10 seconds with the orange color light flashing rapidly. Then corresponding temperature light will start breath flashing that indicates readiness to inhale. Once session is completed, the power button can be pressed again to increase the use for an additional 20 seconds if desired. The GIZA will automatically turn off if not being used for 60s.

Note: Inhaling gently will product the best results.

8. CLEAN

Use a cotton swab to clean the heating atomizer after each use. Once clean allow to air dry or dry off with a soft cloth or towel.

9. ATOMIZER REPLACE

Simply remove the carb cap and glass tube, then unscrew the used heating atomizer from the base. Once the used heating element has been removed you may now install the new atomizer by screwing it directly into the device. Then re-install the glass tube and carb cap.

Note: You may need to press the atomizer a little bit when installing the new coil, because the atomizer uses a spring thread.

MAINTENANCE

After using the GIZA or charging, please allow the device to cool down before storage. It should be stored in a clean, dry place, protected against the effects of weather and kept out of the reach of children and pets. If you have any concerns or if there is any problem, please switch off the GIZA and/or remove it from the charger immediately. Do not try to remedy any defect yourself. Contact our customer service directly at support@kingpalm.com.

Note:

Do not touch the heating element immediately after use.

Do not submerge or clean the battery with water or isopropyl alcohol.

Always detach the GIZA heating element from the battery prior to cleaning.